Error hunt

NLGEOM off, missing TB, one substep, OUTRES,LAST, and ignored convergence.

Bug hunt

#	Fault	Symptom	Correction
1	`NLGEOM,OFF`	Curve matches linear case	`NLGEOM,ON`
2	No `TB,BISO`	Plastic = geometric	Define table and `TBDATA`
3	`NSUBST,1`	Does not converge or underestimates	Ramp with 10 substeps
4	`OUTRES,LAST`	Only one set	`OUTRES,ALL,ALL`
5	Not reading `.out`	False `passes=1`	Verify `n_sets`

Quick check

n_sets=1 after a 10-substep ramp. What is the most likely cause?

OUTRES,ALL,LAST instead of OUTRES,ALL,ALL. KEYOPT(2)=3 is configured incorrectly. /UNITS,SI was not declared.